Model 6198 55 Gallon Chip Trapper System
Applications
- CNC's
- Lathes
- Saws
- Mills
- Drills
- Parts washers
- Pits
- Tanks
- Containers
- Grinders
Advantages
- Removes unwanted solids from liquid
- Recycles coolants
- No moving parts
- No motors to clog or wear out
- Self priming stainless steel pump
- Safe - no electricity
- Built-in pressure/vacuum relief
- Drum is included
- Spill free – auto safety shutoff
- Quiet
What's Included
- Two-way pump assembly (1/4 NPT)
- Directional flow valve
- 30, 55 or 110 gallon drum
- Lever lock drum lid
- Safety shutoff valve
- 10' (3m) of flexible vacuum hose at 1-1/2" (38mm) I.D.
- 20' (6.1m) of compressed air hose
- Chip wand
- Two filter bags
- Drum dolly
Chip Trapper Performance | ||||||
Pressure Supply | Air Consumption | Water Flow Rate | Sound Level | |||
PSIG | BAR | SCFM | SLPM | GPM | LPM | dBA |
80 | 5.5 | 19 | 538 | 30 | 114 | 86 |
How the EXAIR Chip Trapper Works |
|
![]() |
|
The vacuum hose is attached to the barbed connection of the Chip Trapper. The directional flow control valve on top of the drum and knob on the pump are set to the "fill" position. The air supply valve is opened to permit compressed air at 80-100 PSIG (5.5 – 6.9 BAR) to flow through the pump which pulls the liquid through the hose, then into the reusable filter bag. When all liquid is in the drum, the air supply is automatically turned off. The filtered liquid can then be pumped out by setting the directional flow control valve on top of the drum and the knob on the pump to the "empty" position. Once the air supply valve is opened, the air pushes the liquid back through the hose while all solids remain in the reusable filter bag. |
|
Warning: Do not use with any material that has a low flash point or with flammable liquids such as fuel oil, alcohol, mineral spirits, gasoline or kerosene. |
-
Model 6198 55 Gallon Chip Trapper System