Chilling a Mandrel for Picking Up Bottles
A company manufactures medical accessories, one of which is a screen printed bottle. As the day progresses the temperature rises in the mandrels, causing an interference fit. Blowing chilled air, with a Model 3230 Vortex Tube on to the mandrel between bottle pick ups enabled them to prevent thermal growth of the mandrel.
-
Model 75-C Generator for Large Vortex Tubes (75 SCFM)Generators set the total volume of air flow through the Vortex Tube and are available to create the coldest temperature possible or the best Btu/hr. values. Learn More$73.00 -
Model 15-R Generator for Medium Vortex Tubes (15 SCFM)Generators set the total volume of air flow through the Vortex Tube and are available to create the coldest temperature possible or the best Btu/hr. values. Learn More$23.00 -
Model 4-R Generator for Small Vortex Tubes (4 SCFM)Generators set the total volume of air flow through the Vortex Tube and are available to create the coldest temperature possible or the best Btu/hr. values. Learn More$24.00 -
-
Model 25-C Generator for Medium Vortex Tubes (25 SCFM)Generators set the total volume of air flow through the Vortex Tube and are available to create the coldest temperature possible or the best Btu/hr. values. Learn More$23.00 -
Model 3620 Viton O-Ring (Medium Vortex Tube with brass Generator)Viton O-Ring for medium Vortex Tubes
Learn More$4.00 -
Model 5904 Single Point Hose Kit for Mini CoolerFlexible Single Point Hose Kit, recommended when heat is generated over a smaller surface area. Single Point Hose Kits include cone and flat fan nozzles for aiming the cold air flow and are approximately 6" long. Learn More$27.00 -
Model 25-R Generator for Medium Vortex Tubes (25 SCFM)Generators set the total volume of air flow through the Vortex Tube and are available to create the coldest temperature possible or the best Btu/hr. values. Learn More$23.00 -
Model 3499 Vortex Tube (150 SCFM)EXAIR's Vortex Tubes offer a low cost, reliable, maintenance free solution to a variety of industrial spot cooling problems. Using an ordinary supply of compressed air as a power source, vortex tubes create two streams of air, one hot and one cold, with no moving parts. They are constructed of wear resistant stainless steel, which is ideal for corrosive and hygienic environments. Learn More$1,206.00 -
Model 2-TS Taper Sleeves Only for Vortex Tube Generators (2 SCFM)Taper Sleeves are used with small Vortex Tube Generators Learn More$12.00 -
Model 2-C Generator for Small Vortex Tubes (2 SCFM)Generators set the total volume of air flow through the Vortex Tube and are available to create the coldest temperature possible or the best Btu/hr. values. Learn More$24.00 -
